• If
you change the router configuration (refer to "27.10 Router Configuration—VPN—[3-2] IPSec" in the PC
Programming Manual), the affected unit’s system must be restarted in order to rebuild the VPN connection.
At that time, service will be temporarily unavailable.
• It is not possible to use VPN connections using the built-in router for P2P connection as shown in the
following diagrams. In this case, separate P2P groups must be used (refer to "5.2.3 Peer-to-Peer (P2P)
Connection" in the Feature Guide).
Example 1
VPN
VPN
KX-NS1000
Smartphone
Smartphone
Example 2
VPN
VPN
KX-NS1000
IP Extension
Smartphone
KX-NS1000
PC Programming Manual References
27.1.3 Router Configuration
—Setup—[1-1-3] Router Information—VPN Status
27.10 Router Configuration—VPN—[3-2] IPSec
8.6.24 VPN—VPSS Setting
Description
The VPSS (VPN Simple Setting) feature allows you to automatically create a complex, full-mesh VPN. When
constructing a multi-site system with KX-NS1000 PBXs, you can create a VPN with IPsec to ensure secure
communication between sites, but with VPSS, a complex, full-mesh VPN can be created automatically, as
shown in the following figure. This VPN between sites can be easily created and maintained.
Installation Manual 397
8.6.24 VPN—VPSS Setting
To Next Page
Loading...
