• For KX-TDE620 and KX-TDA620, replace the
BUS-S card with a STACK-S (TDE) card.
MPR Card DMPR Card
KX-TDE200/KX-TDA200
MPR Card
KX-TDE100/KX-TDA100 KX-TDA100D
MPR Card BUS-S Card
KX-TDE600/KX-TDA600 KX-TDE620/KX-TDA620
Follow the procedure below to install a STACK-S (TDE) card in the PBX.
1. Remove the front cover as instructed in the Installation Manual for the PBX.
2. Remove the 2 screws from the MPR card slot/BUS-S card slot.
3. Pull the release lever in the direction of the arrow to disconnect the
MPR card/BUS-S card from the back
board. Pull the card from the shelf to remove it.
Note
If a BUS-M card is installed in a KX-TDE600/KX-TDA600
, remove the BUS-M card in the same way
as the MPR card/BUS-S card.
4. Insert the STACK-S (TDE) card into the MPR card slot/BUS-S card slot along the guide rails.
5. Holding the STACK-S (TDE) card, push the release lever in the direction of the arrow so that the
STACK-S (TDE) card engages securely with the connector on the back board.
6. Reinsert the 2 screws and turn them clockwise to fix the STACK-S (TDE) card in place.
7. Close the front cover as instructed in the Installation Manual for the PBX.
174 Installation Manual
4.6.3 STACK-S (TDE) Card (KX-NS0132)
To Next Page
Loading...
