Panasonic KX-NS1000 - Page 211

8. In
Easy Setup, select a value for Select the System Capacity Type under System Capacity Selection.
Note
The system component type selected in this step will be over
-written with the following steps.
9. After Easy Setup is complete, click Utility ® File ® File Transfer PC to PBX.
10. Select the local file that you saved in step 5, and then click Execute.
11. Click System Control ® System Reset.
12. Click Skip.
13. Click OK.
14. Click OK.
Conditions
[Rules for data conversion]
The following table shows the rules for converting system data to a different type.
Condition Rule
Components will increase Copy information for inherited
components.
Set default value for added components.
Components will decrease Copy information for inherited
components.
Delete information for discarded
components.
Components are same Copy information for all the components.
Parameters in components will increase Copy information for inherited parameters.
Set default value for added parameters.
Parameters in components will decrease Copy information for inherited parameters.
Delete information for discarded
parameters.
Parameters in components are same Copy information for all the parameters.
"Components" refers to the PBX's physical cards, virtual cards, etc. If the system component type is different
from before the conversion, the number of components will be increased, decreased or inherited.
The following table gives an example:
Component
Maximum Cards in 1
Unit
Change in components after conversion
Type 1 ® Type 2 ® Type 3 ®
Type
1
Type
2
Type
3
Type 2 Type 3 Type 1 Type 3 Type 1 Type 2
V-SIPGW16 16 16 10 Same Decrease Same Decrease Increase Increase
V-IPGW16 3 3 6 Same Increase Same Increase Decrease Decrease
V-IPEXT32 8 20 8 Increase Same Decrease Decrease Same Increase
V-SIPEXT32 20 8 12 Decrease Decrease Increase Increase Increase Decrease
V-UTEXT32 20 8 12 Decrease Decrease Increase Increase Increase Decrease
Installation Manual 211
5.3 Starting Web Maintenance Console