3. Note
Before changing Numbering Plan settings, when a
V-SIPEXT32 card or V-UTEXT32 card is installed,
change the status of the card(s) to OUS.
a. Click Setup ® PBX Configuration ® System.
b. Click Numbering Plan.
c. Click Main.
d. Click the Features tab.
e. In the TIE Line Access cell, type the dialling
number.
f. Click OK.
4.
a. Click Setup ® PBX Configuration ® Private
Network.
b. Click TIE Table.
c. In
the Own PBX Code cell, type the PBX code of the
local PBX in the network.
d. In the first unused Leading Number cell, type the
PBX code of the remote PBX in the network.
e. In the corresponding Trunk Group list, select the
number of the trunk group to be used when making
calls.
f. If it is necessary to add number(s) to the input
number, enter the number(s) to be added in the
desired Added Number cell.
If it is necessary to delete number(s) from the input
number, enter the number(s) to be deleted in the
desired Removed Number of Digits cell.
g. Click OK.
5.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b. Click Virtual ® V-IPGW16.
c. Move the mouse pointer over the installed
V-IPGW16
card to display the menu of options, and
click Ins (in service).
d. Repeat step c for each installed V-IPGW16 card until
all V-IPGW16 cards are INS.
Programming for the Extension Number Method
1.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b. Click Virtual ® V-IPGW16.
c. Move the mouse pointer over the installed
V-IPGW16
card to display the menu of options, and
click Ous (out of service) to set the card to out of
service.
d. Repeat step c for each installed V-IPGW16 card until
all V-IPGW16 cards are OUS.
e. Click Port Property.
Installation Manual 235
5.6.3 Programming the Network Settings
To Next Page
Loading...
