• Not using a DHCP server (DHCP Server feature or an external DHCP server) when the IP
-PT is on
a remote office LAN
All of the IP addressing information must be assigned manually.
Follow the procedure below to assign the IP addressing information.
If you need to set VLAN parameters, follow the procedure described in "5.8.2 Setting VLAN
Parameters" after assigning the IP addresses, without ending programming.
Note
By
assigning the PBX’s IP address to one IP-PT, it is possible to assign the PBX’s IP address to other
IP-PTs or IP-CSs on the same LAN through system programming. For details, refer to "9.15 PBX
Configuration—[1-1] Configuration—Slot—V-IPEXT32—Port Property—Option—
Announce
Mode" in the PC Programming Manual.
Installation Manual 249
5.8.1 Assigning IP Addressing Information
To Next Page
Loading...
