Continued from previous page
To the VLAN settings
The IP-PT will reboot
and can then be
registered to the PBX.
To end programming
To set VLAN parameters
OR
Press HOLD twice to return
to the Menu screen.
Press STORE.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255
"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except "0.0.0.0" and "255.255.255.255")
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Note
To
confirm the connection to the secondary PBX after assigning IP addressing information, (1) turn the
IP-PT’s power off, and (2) hold the STORE button and 2 key while turning the power on.
Installation Manual 253
5.8.1 Assigning IP Addressing Information
To Next Page
Loading...
