1. Insert the 4 tabs of the wall mounting adaptor into the designated openings in the base, and then slide the
wall mounting adaptor in the direction of the arrow until it clicks.
Slide the wall
mounting adaptor
up to this point.
2. Fasten the wall mounting adaptor to the base with 2 screws (included).
3. Connect the cables to the KX-NT400, and run the cables through the wall mounting adaptor, as shown in
the illustration below.
For details about connecting the cables, see "Connections (Page 147)".
Document Version 2010-01 Operating Instructions 151
Installation and Settings
To Next Page
Loading...
