Panasonic KX-TEM824 - Pulse Restriction [118]; Redialling after Pulse to Tone Conversion [119]; Bell Frequency [120]; Automatic Line Access [121]

3.3 PT Programming
204 Feature Guide
Pulse Restriction [118]
Note
It is programmable whether pulse dialling is sent or not to the telephone company during a conversation
with an outside party when "Pulse" or "Call Block" mode is enabled in Dial Mode [401].
Redialling after Pulse to Tone Conversion [119]
Feature & Programming References
1.5.2.4 Dial Type Selection
Bell Frequency [120]
Note
This programme selects the bell frequency sent to an SLT.
Automatic Line Access [121]
Note
* For New Zealand: 1 or 9
Feature & Programming References
1.5.3.3 Outside (CO) Line Access
2.2.4 Operator/Manager Features
Automatic Rotation for CO Line Access [122]
Feature & Programming References
1.5.3.3 Outside (CO) Line Access
1 1 8
NEXT SELECT STORE END
(Enable/Disable)
1 1 9
NEXT SELECT STORE END
(Enable/Disable)
1 2 0
NEXT SELECT STORE END
(20/25 Hz)
1 2 1
NEXT SELECT STORE END
(Dial 0/9)*
1 2 2
NEXT SELECT STORE END
(Enable/Disable)