1.10 Conversation Features
Feature Guide 83
1.10.6 Flash/Recall
Description
A proprietary telephone (PT) user can use the FLASH/RECALL button to disconnect the current call and
start another call without hanging up. For example, if this button is used to disconnect an outside (CO) line,
the extension user will hear a new dial tone from the same outside (CO) line.
Conditions
• FLASH/RECALL Button Mode
One of the following modes can be selected through system programming ( Flash/Recall Key Mode
[110]):
a) MODE 1: EFA mode ( 1.10.7 External Feature Access (EFA))
An EFA signal is sent for the specified duration ( Flash/Recall Time [418]).
b) MODE 2: Flash/Recall mode
A flash/recall signal is sent for the FLASH/RECALL button is pressed if the length of time that the
button is pressed is longer than the specified duration ( Flash/Recall Time [418]). If the length
of time that the button is pressed is shorter than the specified duration, an EFA signal will be sent
for the specified duration.
• This feature functions only if the FLASH/RECALL button is set to "MODE 2: Flash/Recall mode".
• Disconnect Time
The amount of time between successive accesses to the same outside (CO) line is programmable for
each outside (CO) line ( Disconnect Time [422]).
• This feature generates an SMDR call record ( 1.20.1 Station Message Detail Recording (SMDR))
and restarts the call timer. The notation "F/" will be logged along with the new dial number.
To Next Page
Loading...
