Panasonic KX-TEM824 - DTMF Time [210]; No Dial Disconnection [211]; Extension-To-CO Line Call Duration [212]; Bell-Off Detection [213]

3.3 PT Programming
Feature Guide 211
DTMF Time [210]
Note
This programme selects the minimum duration of the DTMF signal sent to outside (CO) lines that have
been set to "DTMF" in Dial Mode [401].
Feature & Programming References
1.5.2.4 Dial Type Selection
No Dial Disconnection [211]
Feature & Programming References
1.8.1 Toll Restriction (TRS)
Inter-digit Time [208]
Extension-to-CO Line Call Duration [212]
Note
This programme is available for the extension(s) enabled in CO Line Call Duration Limitation [613].
Feature & Programming References
1.10.8 Outside (CO) Line Call Limitation
Bell-off Detection [213]
Note
This programme selects the minimum time required by the PBX to confirm that the bell signal is no
longer being sent from the telephone company, before the PBX acknowledges that the call is lost.
BV Recording Time [214]
2 1 0
NEXT SELECT STORE END
(MODE1: 80 ms/
MODE2: 160 ms)
2 1 1
NEXT SELECT STORE END
(Enable/Disable)
2 1 2
NEXT STORE END
(1
…
32 min)
time
2 1 3
NEXT SELECT STORE END
(3/6/12 s)
2 1 4
NEXT
time
STORE END
(1
…
20 min)