Panasonic Lumix DMC-FZ300

214
SQW0419
Stabilizer, Zoom and Flash
Taking Pictures with Wireless Flashes
5
Press to select [Wireless Channel] and press
[MENU/SET]
Firing Mode Flash output
Flash ratio
6
Press to select the channel and press [MENU/SET]
• Select the same channel as the channel set for the wireless flash
in step
1
.
7
Press to select [Wireless Setup] and press
[MENU/SET]
8
Use to select the item and press [MENU/SET]
[Built-in
Flash] /
[External
Flash]
*
1
[Firing
Mode]
[TTL]: The flash output is automatically adjusted.
[AUTO]
*
2
: Sets the flash output using an external flash.
[MANUAL]
*
2
: Manually sets the flash ratio of an external flash.
[OFF]: The flash of this unit fires only for a communication light
emission.
[Flash
Adjust.]
Adjusts the flash output of the flash of this unit manually when [Firing
Mode] is set to [TTL].
[Manual
Flash
Adjust.]
Sets the flash ratio of an external flash when [Firing Mode] is set to
[MANUAL].
• You can set the flash ratio from [1/1] (flash firing full power) to [1/128]
in 1/3 steps.
[A Group]/
[B Group]/
[C Group]
[Firing
Mode]
[TTL]: The flash output is automatically adjusted.
[AUTO]: The wireless flash automatically sets the flash output.
[MANUAL]: Manually sets the flash ratio of the wireless flash.
[OFF]: The wireless flashes of the set group do not fire.
[Flash
Adjust.]
Adjusts the flash output of the wireless flash manually when [Firing
Mode] is set to [TTL].
[Manual
Flash
Adjust.]
Sets the flash ratio of the wireless flash when [Firing Mode] is set to
[MANUAL].
• You can set the flash ratio from [1/1] (flash firing full power) to [1/128]
in 1/3 steps.
*
1
If an external flash is attached to this unit, [External Flash] is displayed instead of [Built-in Flash].
*
2
You can select these options only when the external flash is attached to the camera.
■
Setting the communication light emission to be used when wireless flash
recording is performed
→ [Rec] → [Flash] → [Communication Light]
Settings: [HIGH] / [STANDARD] / [LOW]