23
SQW0419
Preparations
Attaching the Lens Cap/Shoulder Strap
Attaching the Shoulder Strap
We recommend attaching the shoulder strap when using the camera to prevent it from
dropping.
1
Pass the shoulder strap through the hole at the shoulder
strap eyelet
• Attach the shoulder strap so that the “LUMIX” Logo is on the outside.
Shoulder strap eyelet
2
Pass the end of the shoulder strap through the
stopper, in the direction of the arrow
3
Pass the end of the shoulder strap through the
hole on the other side of the stopper
Pull the shoulder strap
2 cm (0.066 feet) or
more.
4
Pull the shoulder strap and then check that it
will not come out
• Perform steps
1
to
4
and then attach the other side of
the shoulder strap.
• Use the shoulder strap around your shoulder.
– Do not wrap the strap around your neck. It may
result in injury or accident.
• Do not leave the shoulder strap where an infant can
reach it.
– It may result in an accident by mistakenly wrapping
around the neck.
To Next Page
Loading...
