208
SQW0419
Stabilizer, Zoom and Flash
Changing the firing mode (Manual flash)
Recording mode:
You can select whether the flash output is set automatically or manually.
1
Set the menu
→ [Rec] → [Flash] → [Firing Mode]
2
Use to select the item and press [MENU/SET]
[TTL] The camera automatically sets the flash output.
[MANUAL]
You can set the flash ratio manually. Even in the case of dark scenes where
the flash output tends to be higher in [TTL], this mode allows you to take a
picture as intended. The flash ratio (such as [1/1]) is displayed on the flash
icon.
●
This item is available only when the built-in flash is being used.
■
Setting the flash ratio (When [MANUAL] is selected)
Set the menu
→ [Rec] → [Flash] → [Manual Flash Adjust.]
Press to select an item and press [MENU/SET]
• You can set the flash ratio from [1/1] (flash firing full power) to [1/128] in 1/3 steps.
Changing Flash Mode
Recording mode:
Set the flash to match the recording.
1
Set the menu
→ [Rec] → [Flash] → [Flash Mode]
Setting the Flash Functions
To Next Page
Loading...
