333
SQW0419
Others
Message displays
■
Battery
[This battery cannot be used]
• Use a genuine Panasonic battery. Consult the dealer or your nearest Service Center if display still
remains.
• Battery cannot be recognized as terminal is dirty.
→ Wipe any dirt away from the battery terminal.
■
Wi-Fi function
[Failed to connect wireless access point] / [Connection failed] / [No destination found]
• Check following regarding the wireless access point.
– The wireless access point information set on this unit is wrong. Check the authentication type,
encryption type, and encryption key. (→294)
– Power of the wireless access point is not turned on.
– Setting of the wireless access point is not supported by this unit.
• Check the network setting of the destination.
• Radio waves from other devices may block the connection to a wireless access point.
→ Check other devices that are connected to the wireless access point and devices that use the
2.4 GHz band.
[No picture to send]
• This is displayed when there is no image to transmit due to the restriction of the destination.
Check the file type of the image to transmit. (→274)
[Connection failed. Please retry in a few minutes.] / [Network disconnected. Transfer stopped.]
• Radio waves from the wireless access point are getting weak.
→ Perform the connection closer to the wireless access point.
• There is no reply from the server or it has exceeded the communication processing time.
→ Try again after a while.
• Depending on the wireless access point, connection may be automatically disconnected after
specific time has passed.
→ Reconnect the connection again.
[Upload to the Cloud Folder is available after Cloud Sync settings have been set up on
downloadable devices such as PCs or smartphones.]
• Devices that download images from a cloud folder are not registered.
• Perform Cloud Sync setting. Configure the settings on a PC with “PHOTOfunSTUDIO” or on a
smartphone with “Image App”. For details on [Cloud Sync. Service], refer to (→286).
To Next Page
Loading...
