Panasonic Lumix DMC-L10 - Connecting to a PC; Connecting to Other Equipment

Connecting to other equipment
118
VQT1G28
Connecting to other equipment
Connecting to a PC
You can acquire recorded pictures to a PC
by connecting the camera and the PC.
The software [LUMIX Simple Viewer] or
[PHOTOfunSTUDIO-viewer-]
(for Windows
®
) on the CD-ROM (supplied)
allows you to easily acquire pictures
recorded with the camera to a PC, print
them and send them by e-mail.
If you use “Windows 98/98SE”, install
the USB driver and then connect it to
the computer.
Read the separate operating instructions
for the supplied software for more
information about the software in the
CD-ROM (supplied) and how to install it.
A USB connection cable (supplied)
B DC cable (DMW-DCC1; optional)
C This message appears during data
transfer.
• Use a sufficiently charged battery (P18) or
the AC adaptor (P128).
• Turn the camera off and then insert or
remove the cable for the AC adaptor
(P128).
1 Turn on the camera and the PC.
2 Connect the camera to a PC via
the USB connection cable
A
(supplied).
• Connect the USB connection cable with
the [ ] mark facing the [2] mark on
the [DIGITAL] socket.
• Hold the USB connection cable at D
and insert straight in or take straight
out. (If you forcibly insert the USB
connection cable at a slant or upside
down you can deform the connection
terminals and damage the camera or
the connected equipment.)
3 Press 3 to select [PC] and then
press [MENU/SET].
• If you set [USB MODE] in the [SETUP]
menu to [PC] in advance, it is not
necessary to set this every time you
connect to a PC. (P30)
• If you set [USB MODE] to
[PictBridge (PTP)] and then connect the
camera to the PC, messages may
appear on the screen of the PC.
Select [CANCEL] to close the
messages and disconnect the camera
from the PC. Set [USB MODE] to [PC]
again.
ACCESS
D
C
B
A
USB MODE
PictBridge(PTP)
SELECT
SET
MENU
PC
PLEASE SELECT
THE USB MODE
MENU
/SET
VQT1G28ENG_L10KP.book 118 ページ ２００７年９月６日 木曜日 午前９時２９分