Preparation
16
VQT1G28
∫ Temporarily storing the lens hood
1 Turn the lens hood in the
direction of the arrow to detach it.
2 Reverse the lens hood and then
attach it in the same way as
shown previously.
• Attach the lens cap.
• When temporarily storing the lens
hood, check that it is firmly attached
and that it does not appear in the
picture.
• Hold the short sides of the lens hood
when attaching or detaching it.
• When taking pictures with the flash with
the lens hood attached, the lower portion
of the screen may turn dark (vignetting
effect) and the control of the flash may be
disabled because the photo flash may be
obscured by the lens hood. We
recommend detaching the lens hood.
• When using the AF assist lamp in the
dark, detach the lens hood.
• For details on how to attach the MC
protector and the PL filter, refer to P126.
Attaching the Strap
1 Pass the strap through the strap
eyelet on the camera body.
A Eyepiece cap
• Attach the strap so that the side with
the eyepiece cap attached to it is near
the Viewfinder.
2 Pass the end of the strap through
the ring in the direction of the
arrow and then pass it through
the stopper.
3 Pass the end of the strap through
the hole on the other side of the
stopper.
A
VQT1G28ENG_L10KP.book 16 ページ ２００７年９月６日 木曜日 午前９時２９分
To Next Page
Loading...
