Panasonic Lumix DMC-L10 - Single Picture

Connecting to other equipment
121
VQT1G28
1 Turn on the camera and the
printer.
2 Connect the camera to a printer
via the USB connection cable
(supplied).
• Connect the USB connection cable with
the [ ] mark facing the [2] mark on
the [DIGITAL] socket.
• Hold the USB connection cable at C
and insert straight in or take straight
out.
3 Press 4 to select
[PictBridge (PTP)] and then press
[MENU/SET].
• If you set [USB MODE] in the [SETUP]
menu to [PictBridge (PTP)] in advance,
it is not necessary to set this every time
you connect to a Printer. (P30)
• Do not use any other USB connection
cables except the supplied one.
• If you want to print the age in [BABY1]/
[BABY2] or [PET] in scene mode, use the
software [LUMIX Simple Viewer] or
[PHOTOfunSTUDIO-viewer-] in the
CD-ROM (supplied) and print from the
PC.
∫ Single picture
1 Press 3 to select
[SINGLE PICTURE] and then
press [MENU/SET].
2 Press 2/1 to select the picture
and then press 4.
• The message disappears in about
2 seconds.
3 Press 3 to select [PRINT START]
and then press [MENU/SET].
• Press [MENU/SET] to cancel printing.
4 Disconnect the USB connection
cable after printing.
USB MODE
SELECT SET
MENU
PC
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
MENU
/SET
PictBridge
SET
SELECT
SINGLE PICTURE
MENU
DPOF PICTURE
MENU
/SET
PLEASE SELECT
THE PICTURE TO PRINT
PictBridge
SELECT
EXIT
MENU
PRINT
1/19
100 - 0001
CANCEL SELECT SET
MENU
PRINT START
PRINT WITH DATE
NUM. OF PRINTS
PAPER SIZE
PAGE LAYOUT
SINGLE PICTURE
1
MENU
/SET
VQT1G28ENG_L10KP.book 121 ページ ２００７年９月６日 木曜日 午前９時２９分