Panasonic Lumix DMC-L10 - Taking Pictures with the Self-Timer

Advanced
74
VQT1G28
Taking Pictures with
the Self-timer
1 Set the drive mode lever to [ ].
A Self-timer set to [ ]
2 Focus on the subject and take a
picture.
• A picture is not taken until the subject is
brought into focus.
• If you want to press the shutter button
fully to take a picture even when the
subject is not focused, set
[FOCUS PRIORITY] in the [CUSTOM
MENU] menu to [OFF]. (P106)
• The self-timer indicator
B blinks and the
shutter is activated
after 10 seconds (or
2 seconds).
•
When [ ] is selected, the self-timer
indicator blinks again after the first and
the second pictures are taken and the
shutter is activated 2 seconds after it
blinks.
• If you press [MENU/SET] while taking a
picture with the self-timer, it is canceled.
∫ Changing the time setting for the
self-timer
1 Press [MENU/SET] to display the
menu.
2 Press 3/4/2/1 to select
[SELF-TIMER] in the [REC] menu
[ ] and then press 1.
3 Press 3/4 to select the mode
and then press [MENU/SET].
• If you set [ ], after 10 seconds the
camera takes 3 pictures at about
2 second intervals.
• You can also use the front dial or the
rear dial to select a menu item.
4 Press [MENU/SET] to close the
menu.
• You can also press the shutter button
halfway to close the menu.
• When using a tripod etc., setting the
self-timer to 2 seconds is a convenient
way to avoid the jitter caused by pressing
the shutter button.
• If you set [MIRROR UP] in the [REC]
mode menu to [ON], you can prevent jitter
(camera shake) caused by the mirror.
(P102)
A
B
Item Settings
10 seconds
10 seconds/3 pictures
2second
MENU
/SET
VQT1G28ENG_L10KP.book 74 ページ ２００７年９月６日 木曜日 午前９時２９分