Preparation
21
VQT1G28
Inserting/Removing
the Battery
• Check that the camera is turned off.
• Close the flash.
1 Slide the release lever in the
direction of the arrow (OPEN
side) and then open the battery
door.
• Always use genuine Panasonic
batteries (DMW-BLA13PP).
• If you use other batteries, we cannot
guarantee the quality of this product.
2 Insert:
Insert the charged battery fully
until it clicks.
Remove:
Push the lever A in the direction
of the arrow to remove.
• Be careful of the direction indicated by
the mark [ ] on the battery when
inserting the battery.
3 1:
Close the battery door.
2:
Slide the release lever in the
direction of the arrow (CLOSE
side) and then close it firmly.
• Remove the battery after use.
• Do not remove the card or the battery
while the card is being accessed. The
data may be damaged. (P23)
• Do not remove the battery with the
camera turned on since the settings on
the camera may not be stored properly.
• The supplied battery is designed only
for the camera. Do not use it with any
other equipment.
A
VQT1G28ENG_L10KP.book 21 ページ ２００７年９月６日 木曜日 午前９時２９分
To Next Page
Loading...
