Others
125
VQT1G28
Others
Using the External
Flash
If you use an external flash, the available
flash range increases compared to the
camera’s built in flash.
∫ Using the dedicated flash
(DMW-FL500; optional)
1 Attach the dedicated flash to the
hot shoe A and then turn on the
camera and the dedicated flash.
• Be sure to firmly secure to the
dedicated flash with the lock ring B.
2 Press [MENU/SET] to display the
menu.
3 Press 3/4/2/1 to select
[FLASH] in the [REC] menu [ ]
and then press 1.
4 Press 3/4 to select the mode
and then press [MENU/SET].
5 Press [MENU/SET] to close the
menu.
• You can also press the shutter button
halfway to close the menu.
∫ When using other commercially
available external flashes without
communication functions with the
camera (DMC-L10)
• It is necessary to set the exposure on the
external flash. If you want to use the
external flash in auto mode, use an
external flash that allows you to set the
aperture value and the ISO sensitivity to
match the settings on the camera.
• Set to Aperture-priority AE mode [ ] or
Manual exposure mode [ ] on the
camera and then set the same aperture
value and ISO sensitivity on the external
flash. (The exposure cannot be
compensated adequately due to the
change on the aperture value in
Shutter-priority AE mode [ ] and the
external flash cannot control the light
adequately in Program AE mode [ ]
because the aperture value cannot be
fixed.)
• You can also use [FUNC] to set. (P91)
• You can set the aperture value, the shutter
speed and the ISO sensitivity on the
camera even when attaching the external
flash.
• Some commercial external flashes have
synchro terminals with high-voltage or
reversed polarity. Using such external
flashes may cause a malfunction or the
camera may not operate normally. Be sure
to use Panasonic’s external flash
(DMW-FL500).
Icon Setting
External flash Forced ON
External flash Slow sync.
MENU
/SET
VQT1G28ENG_L10KP.book 125 ページ ２００７年９月６日 木曜日 午前９時２９分
To Next Page
Loading...
