Preparation
15
VQT1G28
∫ Detaching a lens from the camera
body
• Check that the camera is turned off.
1 Attach the lens cap.
2 Press the lens release button D
while turning the lens as far as
possible in the direction of the
arrow to detach it.
• Always attach the body cap to the
camera body so that dirt or dust does
not get inside.
• Attach the lens rear cap so that the lens
contact point does not get scratched.
• Change lenses where there is not a lot of
dirt or dust.
• When you turn the camera off or carry the
camera, attach the lens cap to protect the
surface of the lens.
• Detach the lens cap before taking
pictures.
• Be careful not to lose the lens cap, the
lens rear cap and the body cap.
Attaching the Lens
Hood
In bright sunlight or backlight, the lens hood
will minimize lens flare and ghosting. The
lens hood cuts off excess lighting and
improves the picture quality.
• Check that the camera is turned off.
• Close the flash.
Insert the lens hood on the lens
with the short sides at the top and
bottom and then turn it in the
direction of the arrow until it
clicks.
A Fit to the mark.
D
A
VQT1G28ENG_L10KP.book 15 ページ ２００７年９月６日 木曜日 午前９時２９分
To Next Page
Loading...
