Preparation
22
VQT1G28
Inserting/Removing
the Card (Optional)
• Check that the camera is turned off.
• Close the flash.
• Prepare a card. (optional)
1 Slide the card door to open it.
2 Insert:
Insert the card fully until it clicks
and it is locked.
Remove:
Push the card until it clicks, then
pull the card out upright.
• Check the direction of the card.
• Do not touch the connection terminals
on the back side of the card.
• The card may be damaged if it is not
fully inserted.
3 1:
Close the card door.
2:
Slide the card door to the end and
then close it firmly.
• If the card door cannot be completely
closed, remove the card and insert it
again.
• Always turn the camera off before
opening the card door.
• The card and the data may be damaged
if it is inserted or removed while the
camera is on.
• We recommend using a Panasonic SD
Memory Card or SDHC Memory Card.
(P6)
VQT1G28ENG_L10KP.book 22 ページ ２００７年９月６日 木曜日 午前９時２９分
To Next Page
Loading...
