Preparation
30
VQT1G28
[USB MODE]
Press [ ] to display the [SETUP] menu
and select the item to set. (P26)
Select the USB communication system
after or before connecting the camera to
your PC or your printer with the USB
connection cable (supplied). (P118, 120)
[ SELECT ON CONNECTION]:
Select either [PC] or [PictBridge (PTP)]
if you connected the camera to a PC or
a printer supporting PictBridge.
[PC]:
Set after or before connecting to a PC.
[ PictBridge (PTP)]:
Set after or before connecting to a
printer supporting PictBridge.
• When [PC] is selected, the camera is
connected via the “USB Mass Storage”
communication system.
• When [PictBridge (PTP)] is selected, the
camera is connected via the “PTP (Picture
Transfer Protocol)” communication
system.
[HIGHLIGHT]
Press [ ] to display the [SETUP] menu
and select the item to set. (P26)
• If there are any white saturated areas, we
recommend compensating the exposure
towards negative (P44) referring to the
histogram (P55) and then taking the
picture again. It may result in a better
quality picture.
• There may be white saturated areas if the
distance between the camera and the
subject is too close when taking pictures
with the flash.
If [HIGHLIGHT] is set to [ON] in this case,
the area directly illuminated by the photo
flash will become white saturated and
appear blinking in black and white on the
LCD monitor.
[VIDEO OUT]
Press [ ] to display the [SETUP] menu
and select the item to set. (P26)
Set to match the color television system in
each country.
• Video output is available in playback
mode only.
MENU
/SET
[OFF] No highlight display
[ON] When the auto review function
is activated or when playing
back, white saturated areas
appear blinking in black and
white.
[NTSC]: Video output is set to NTSC
system.
[PAL]: Video output is set to PAL
system.
MENU
/SET
[ON]
[OFF]
MENU
/SET
VQT1G28ENG_L10KP.book 30 ページ ２００７年９月６日 木曜日 午前９時２９分
To Next Page
Loading...
