Basic
46
VQT1G28
∫ Technique for Manual focus
1 Rotate the focus ring.
2 Rotate it a little more.
3 Finely focus on the subject by rotating
the focus ring slowly in reverse.
• If you use the zoom function after focusing
on the subject, focus on the subject again.
• After turning the camera off and then on
again or canceling power save mode,
focus on the subject again.
∫ About the focus distance reference
mark
The focus distance reference mark is a
mark used to measure the focus distance.
Use this when taking pictures with manual
focus or taking close-up pictures.
A Focus distance reference mark
B Focus distance reference line
C [0.29] m (0.95 feet)
• If the distance between the camera and
the subject is beyond the focus range of
the camera, the picture may not be
properly focused even if the focus
indication lights.
• The available flash range is about 2.0 m
(6.6 feet) to 5.5 m (18.0 feet) (Wide)
(When the ISO sensitivity is set to
[AUTO].). We recommend setting the flash
to Forced OFF [ ] when you take
pictures at close range.
• If you are taking close-up pictures
– We recommend using a tripod and the
self-timer (P74).
– The effective focus range (depth of field)
is significantly narrowed. Therefore, if
the distance between the camera and
the subject is changed after focusing on
the subject, it may become difficult to
focus on it again.
– The resolution of the periphery of the
picture may decrease slightly. This is not
a malfunction.
B
C
A
VQT1G28ENG_L10KP.book 46 ページ ２００７年９月６日 木曜日 午前９時２９分
To Next Page
Loading...
