283
SQW0566
Playing Back and Editing Pictures
Using the [Playback] menu
[Location Logging]
After you send location information (latitude and longitude) obtained by your smartphone/
tablet to this unit, you can write this information on pictures using the unit.
Preparation
Send location information to this unit from your smartphone/tablet. (→314)
• You must install “Panasonic Image App” on your smartphone/tablet. (→305)
1
Set the menu
→ [Playback] → [Location Logging] → [Add Location Data]
2
Use to select a period for writing location information, and press
[MENU/SET]
• [ ] is displayed for pictures that have location information written to it.
■
Abort writing location information
Press [MENU/SET] while location information is being written
• [ ] is displayed for the period of the abort operation.
If selected again while [
] is displayed, writing location information will resume where it left off.
■
Delete received location information
Use to select [Delete Location Data] and press [MENU/SET]
Use to select a period for deleting location information, and press [MENU/SET]
●
The location information cannot be written in the following cases:
• Pictures that were recorded after you sent the location information (→314)
• Pictures that already have location information
• Motion pictures recorded in [AVCHD] format
• Protected pictures
• If there is not enough free space on your card
• Card switch is in “LOCK” position.
• Pictures recorded using cameras other than this unit
Writing the location information using a smartphone/tablet
When you use your smartphone/tablet as a remote controller for this unit, you can write
the location information on pictures using the smartphone/tablet. (→315)
To Next Page
Loading...
