VQT2R48 87
Change the recorded place name information
If positioning results and current position are different from each other, or if there are
other candidate locations, you can change the information to nearby place names or
landmarks.
Displayed when other location name information can be
selected.
Select [GPS AREA SELECT]
(20), from the [TRAVEL
MODE] menu
Select the item to change
display
From the displayed
candidates, select the
desired place name or
landmark to be recorded
Return to the menu screen
The location name information consists of location names and landmarks that are
found via a search of the camera’s database based on the latitude and longitude that
were acquired in positioning, and the most appropriate items are displayed in the
following order of priority. (Sometimes the nearest items are not displayed.)
Landmark names and the corresponding location names within 1 km of the current position
Location names for places with landmarks or other points of interest within 10 km of the current
position
• If there are no location names or landmarks that comply with the conditions above, “---” is
displayed. Even when “---” is displayed, in some cases location name information can be
selected in [GPS AREA SELECT].
• In some cases, the landmark that you are looking for may not have been registered. Landmarks
and other location name information are current as of February 2010. (Landmark types 173)
The location name information (location name or landmark name) may be different
from the official name.
To Next Page
Loading...
Need help?
General
