144 VQT2R48
Printing
To cancel print Press [MENU/SET]
Do not use any other USB connection cables except the supplied one.
Disconnect USB connection cable after printing.
Turn off power before inserting or removing memory cards.
When the battery begins to run out during communication, a warning beep sounds.
Cancel printing and disconnect USB connection cable (recharge the battery before
reconnecting).
Setting the [USB MODE] to [PictBridge (PTP)] removes the need to make the setting
each time the camera is connected to the printer.
Motion pictures recorded in [AVCHD Lite] format cannot be printed.
You can connect directly to a PictBridge-
compatible printer for printing.
Getting Ready:
• Charge the battery sufficiently. Or, connect
the AC adaptor (optional) and DC coupler
(optional).
• Insert card and set mode dial to any setting
except
. When copying pictures from the
built-in memory, remove any memory cards.
(Copy [CLIPBOARD] pictures to the card in
advance)
• Adjust the print quality or other settings on
your printer, as needed.
Turn on power of camera
and printer
Connect camera to printer
• Please make sure you use the
supplied USB connection cable. Use
of cables other than the supplied
USB connection cable may cause
malfunction.
Select [PictBridge (PTP)]
on the camera
When [CONNECTING TO PC…]
is displayed, cancel the connection
and set [USB MODE] (26) to either
[SELECT ON CONNECTION] or
[PictBridge (PTP)].
Press to select a
picture to print and press
[MENU/SET]
Select [PRINT START]
(Print settings (146))
Check socket direction and insert straight in.
(Damage to socket shape can lead to faulty
operation.)
• Do not disconnect the USB connection cable when
the cable disconnection icon
is displayed (may
not be displayed with some printers).
USB connection cable
(always use cable supplied)
Example of DMC-TZ10/
DMC-ZS7
To Next Page
Loading...
