14 VQT2R48
Inserting and removing the card (optional)/
the battery
Set the camera ON/OFF switch to OFF
Slide to the [OPEN] position
and open the lid
[OPEN] [LOCK]
Release lever
Completely insert battery
and card
• Battery: Push in until the lever is locked
• Memory card: Push in until it clicks
Close lid
Slide to the [LOCK] position.
To remove
• To remove battery: • To remove card:
move lever in
direction of arrow.
Lever press down in
centre.
Always use genuine Panasonic batteries.
If you use other batteries, we cannot guarantee the quality of this product.
Remove battery from camera after use.
• Store the battery in battery carrying case (supplied).
To remove the card or battery, turn the camera off and wait until
the LUMIX indicator on the LCD monitor goes off. (Failure to wait
may cause the camera to malfunction and may damage the card
or recorded data.)
Keep the Memory Card out of reach of children to prevent
swallowing.
Charged battery (check orientation)
Card (check orientation: terminals face
LCD)
Do not
touch
terminal
Lever
To Next Page
Loading...
Need help?
General
