Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 139
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON] Displays the input guide.
[OFF] Hides the input guide.
Setting [WARNING MESSAGE]
Set the display/hide of the warning message.
1) Press as to select [ON-SCREEN DISPLAY].
2) Press the <ENTER> button.
f The [ON-SCREEN DISPLAY] screen is displayed.
3) Press as to select [WARNING MESSAGE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON] Displays the warning message.
[OFF] Hides the warning message.
Note
f If [OFF] is set, the warning message will not be displayed on the projected image even when warning condition such as [TEMPERATURE
WARNING] is detected while using the projector. Also, the following countdown message is not displayed: the message until the power
is turned o after the no signal shut‑o function is executed; the message until the light source is turned o after the no signal lights‑out
function is executed
[MENU MODE]
Set the display mode of the menu screen (OSD).
1) Press as to select [MENU MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL] Displays all menu items.
[SIMPLE] Displays some of the menu items that are used for basic setting or adjustment.
Note
f For the menu items that are displayed when [SIMPLE] is set, refer to “Main menu” (x page 89), “Sub-menu” (x page 90).
[BACK COLOR]
Set the display of the projection screen when a signal is not input.
1) Press as to select [BACK COLOR].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[BLUE] Displays blue in the entire projection screen.
[BLACK] Displays black in the entire projection screen.
[DEFAULT LOGO] Displays the Panasonic logo in the projection screen.
[USER LOGO] Displays the image registered by the user in the projection screen.
Note
f The [BACK COLOR] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [NO SIGNAL SETTING] → [BACK COLOR]
f To create and register the [USER LOGO] image, use “Logo Transfer Software”. The software can be downloaded from the following website.
https://panasonic.net/cns/projector/
When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for “NO
SIGNAL SLEEP” of the DIGITAL LINK output supported device should be set to “OFF” to avoid interruption of communication.
To Next Page
Loading...
