Chapter 3 Basic Operations — Projecting
ENGLISH - 81
Moving the projection lens to the home position
Operate in following procedure to move the projection lens to the home position.
When operating from the main menu
1) Press the <MENU> button.
f The [MAIN MENU] screen is displayed.
2) Press as to select [PROJECTOR SETUP].
3) Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
4) Press as to select [LENS].
5) Press the <ENTER> button.
f The [LENS] screen is displayed.
6) Press as to select [LENS HOME POSITION].
7) Press the <ENTER> button.
f The conrmation screen is displayed.
8) Press qw to select [OK], and press the <ENTER> button.
f The projection lens is moved to the home position.
Note
f [PROGRESS] is displayed in the menu while the projection lens is moved to the home position.
f The home position is an origin position of the lens shift (vertical position and horizontal position of the lens) based on the calibration result. It
does not match with the optical image center position.
When operating from the lens shift adjustment screen
1) Press the <DEFAULT> button on the remote control while displaying the lens shift adjustment screen.
f The conrmation screen is displayed.
2) Press qw to select [OK], and press the <ENTER> button.
f The projection lens is moved to the home position.
Note
f The [HOME POSITION] screen can also be displayed by pressing the <LENS> button on the control panel or the <SHIFT> button on the
remote control for three seconds or longer.
f [PROGRESS] is displayed in the menu while the projection lens is moved to the home position.
To Next Page
Loading...
