Panasonic PT-REQ12 Series

Chapter 5 Operations — Using the web control function
ENGLISH - 227
Calibration execution page
1) Click [Projector control] → [Detail control] → [LENS] → [CALIBRATION].
f The conrmation screen is displayed.
2) Click [OK].
f The calibrations for the lens shift and focus are started.
Lens position setting page
Click [Projector control] → [Detail control] → [LENS] → [SET POSITION].
4
3
2
1
1 [Get]
Acquires the current lens position and displays the acquired
values in the lens position information eld.
2 Lens position information eld
Enters the lens position (vertical position, horizontal position,
focus position, zoom position and periphery focus position).
3 [Back]
Returns to the [LENS] page.
4 [Apply]
Moves to the lens position displayed in the lens position
information eld.
Note
f Periphery focus is displayed in lens position information eld only when following projection lens is attached.
Zoom Lens (Model No.: ET-C1W300, ET-C1W400, ET-C1W500)
[Detailed set up]
[Network cong] page
Click [Detailed set up] → [Network cong].
1) Click [Network config].
f Click [Network cong] to display the [CAUTION!] screen.