Panasonic PT-REQ12 Series

Chapter 7 Appendix — Specications
282 - ENGLISH
Specications
The specications of the projector are as follows.
Display system 1-chip DLP projection system
Display device
Size of e󰀨ective display
area
20.3 mm (0.8") x 1 (aspect ratio 16:10)
Number of pixels
2 304 000 pixels (1 920 x 1 200
dots)
when [QUAD PIXEL DRIVE] is set to [OFF]
9 216 000 pixels (3 840 x 2 400
dots)
when [QUAD PIXEL DRIVE] is set to [ON]
Projection lens
Supplied projection
lens
PT-REQ12, PT-REQ10,
PT-REQ80
Standard zoom lens
f Zoom magnication: 1.54 x
f Focal length: 23.9 mm to 37.2 mm
f F number: 1.84 to 2.31
PT-REQ12L, PT-REQ10L,
PT-REQ80L
Optional
Zoom Powered
Focus Powered
Lens shift Powered (Horizontal/Vertical)
Changeable lens Yes
Light source Laser diode
Screen size 1.78 m (70") to 17.80 m (700")
Light output
*1*2
PT-REQ12, PT-REQ12L
12 000 lm
(when [OPERATING MODE] is set to [NORMAL])
9 600 lm
(when [OPERATING MODE] is set to [ECO] or [QUIET])
PT-REQ10, PT-REQ10L
10 000 lm
(when [OPERATING MODE] is set to [NORMAL])
8 000 lm
(when [OPERATING MODE] is set to [ECO] or [QUIET])
PT-REQ80, PT-REQ80L
8 000 lm
(when [OPERATING MODE] is set to [NORMAL])
6 400 lm
(when [OPERATING MODE] is set to [ECO] or [QUIET])
Contrast ratio
*1*2
25 000:1 when [DYNAMIC CONTRAST] is set to [3]
Center to corner zone ratio
*1
90 %
Displayable
scanning
frequency
Horizontal 27 kHz to 291.6 kHz
Vertical 24 Hz to 240.0 Hz
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2020 international standards.
*2 This is the value when the Zoom Lens (Model No.: ET-C1S600) is used. The value varies depending on the lens.