Panasonic PT-REQ12 Series

Chapter 3 Basic Operations — Switching on/o󰀨 the projector
76 - ENGLISH
Switching o󰀨 the projector
1)
2)
1)
2)
4)
3)
1) Press the <STANDBY> button.
f The [POWER OFF(STANDBY)] conrmation screen is displayed.
2) Press qw to select [OK], and press the <ENTER> button.
(Or press the <STANDBY> button again.)
f Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights in orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
blinks red.
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f For approximately ve seconds after the projector is turned o󰀨, the indicator does not light up even if the power is turned on.
f Even when the <STANDBY> button is pressed and the projector is switched o󰀨, the projector consumes power if the main power
of the projector is on.
Usage of some functions is restricted but the power consumption during the standby mode is conserved when the [PROJECTOR SETUP]
menu → [STANDBY MODE] is set to [ECO].
f While projecting, the power can be turned o󰀨 by pressing the <OFF> side of the <MAIN POWER> switch, or by directly using the breaker
under conditions where the <MAIN POWER> switch of the projector cannot be switched o󰀨/on easily such as while installing on the ceiling.
However, the settings or adjustments performed right before the power is turned o󰀨 may not be reected.