Panasonic PT-REQ12 Series

Chapter 2 Getting Started — Removing/attaching the projection lens
52 - ENGLISH
Attaching the projection lens
Attach the projection lens using the following procedure.
Start from Step 2) when the dustproof sponge is already removed.
1) Remove the dustproof sponge. (Fig. 1)
2) Align the protruding mark on the projection lens with the protruding mark of the projector, and insert
the projection lens all the way in. (Fig. 2)
f When inserting the projection lens, be careful not to damage the connector.
3) Turn the projection lens clockwise until it clicks. (Fig. 3)
Attention
f Turn the projection lens counterclockwise to conrm that it does not come out.
f If the projection lens was replaced, execute the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION]. (x page 150)
Dustproof sponge
Fig. 1
Protruding mark on the projector
Protruding mark
on the projection lens
Projection lens
Fig. 2 Fig. 3
Connector