Panasonic PT-REQ12 Series

Chapter 4 Settings — [PROJECTOR SETUP] menu
146 - ENGLISH
[CEILING]
Select this item when installing the projector with the top surface of the projector facing down such as
ceiling attachment.
Projected image is inverted upside down.
Note
f Refer to “Angle sensor” (x page 43) for details on the range of the installation attitude that can be detected by the built-in angle sensor.
[LENS]
Perform the setting and operation regarding the projection lens.
[LENS TYPE]
When the projector is used for the rst time or when the projection lens is replaced, conrm the [LENS TYPE]
setting.
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Confirm the type of the projection lens in [LENS TYPE].
Note
f The information of the projection lens is automatically acquired when the projector is turned on. The acquired information is displayed in
[LENS TYPE].
f [---] is displayed in [LENS TYPE] if the automatic acquisition of the projection lens information fails.
f Turn o󰀨 the projector and reattach the projection lens when [‑‑‑] is displayed in [LENS TYPE].
[LENS INFORMATION SETTING]
Conrming the projection lens information
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS INFORMATION SETTING].
4) Press the <ENTER> button.
f The [LENS INFORMATION SETTING] screen is displayed.
[LENS ID] Displays the set ID.
[LENS NAME] Displays the set name.
[LENS TYPE] Displays the projection lens type.
Setting ID to the projection lens
Write the identication information unique to the projection lens into the EEPROM built in the projection lens. Set
ID if required.
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS INFORMATION SETTING].
4) Press the <ENTER> button.
f The [LENS INFORMATION SETTING] screen is displayed.
5) Press as to select [LENS ID].