Panasonic PT-REQ12 Series

Chapter 7 Appendix — Technical information
ENGLISH - 273
r RASTER PATTERN
Performance Parameter Default value
No operation 0-15
0
OFF 16-31
WHITE 32-47
YELLOW 48-63
CYAN 64-79
GREEN 80-95
MAGENTA 96-111
RED 112-127
BLUE 128-143
BLACK 144-159
USER LOGO 160-175
No operation 176-255
r ENABLE/DISABLE
Operation for all channels is not accepted when set to “Disable”.
Performance Parameter Default value
Disable 0-127
0
Enable 128-255
Note
f If the projector is operated using the remote control or the control panel, or by the control command while controlling the projector using the
Art-Net function, the setting of the DMX controller or computer application may be di󰀨erent from the projector status. To reect the controls
of all channels to the projector, set “ENABLE/DISABLE” of channel 11 to “Disable” and then back to “Enable”.
f To create and register the [USER LOGO] image, use “Logo Transfer Software”. The software can be downloaded from the following website.
https://panasonic.net/cns/projector/
Control commands via LAN
The projector can be controlled via the <LAN> terminal equipped on the projector as standard or the <DIGITAL
LINK IN/LAN> terminal of the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) installed in the slot
by using the control command format via the <SERIAL IN> terminal.
For examples of the available commands, refer to “Control command” (x page 280).
Note
f To send/receive the command via LAN, it is necessary to set the password of the administrator account. (x page 202)
When connecting in protect mode
Connecting
Following is the connection method when the [NETWORK] menu → [NETWORK SECURITY] → [COMMAND
PROTECT] is set to [ENABLE].
1) Obtain the IP address and port number (Initial set value = 1024) of the projector and request a
connection to the projector.
f You can obtain both the IP address and the port number from the menu screen of the projector.
IP address
Obtain from the [NETWORK] menu → [NETWORK STATUS].
Port number
Obtain from the [NETWORK] menu → [NETWORK CONTROL] → [COMMAND PORT].
2) Check the response from the projector.
Data section Blank Mode Blank Random number section
Termination
symbol
Command
example
“NTCONTROL”
(ASCII string)
‘ ’
0x20
‘1’
0x31
‘ ’
0x20
“zzzzzzzz”
(ASCII code hex number)
(CR)
0x0d