Chapter 4 Settings — [ADVANCED MENU] menu
ENGLISH - 113
[ADVANCED MENU] menu
On the menu screen, select [ADVANCED MENU] from the main menu, and select an item from the sub-
menu.
Refer to “Navigating through the menu” (x page 88) for the operation of the menu screen.
[DIGITAL CINEMA REALITY]
The picture quality is enhanced by raising the vertical resolution higher performing the cinema processing when
interlaced video signal is input.
1) Press as to select [DIGITAL CINEMA REALITY].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically detects the input signal and performs cinema processing. (Factory default setting)
[OFF] Does not perform cinema processing.
[30p FIXED]
When 60 Hz vertical scanning
frequency signals are input
Performs forced cinema processing (2:2 pulldown).
[25p FIXED]
When 50 Hz vertical scanning
frequency signals are input
Note
f In [DIGITAL CINEMA REALITY], the picture quality will degrade when a signal other than the 2:2 pulldown is set as [25p FIXED] or [30p
FIXED]. (Vertical resolution will degrade.)
[GRADATION SMOOTHER]
Set the correction level to reduce the dierence in level of gradation.
1) Press as to select [GRADATION SMOOTHER].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Disables the gradation smoother function.
[1] Performs weak correction.
[2] Performs moderate correction. (Factory default setting)
[3] Performs strong correction.
[BLANKING]
Adjust the blanking width if there is a noise at the edge of the screen or the image is slightly running out from the
screen.
1) Press as to select [BLANKING].
2) Press the <ENTER> button.
f The [BLANKING] adjustment screen is displayed.
3) Press as to select [UPPER], [LOWER], [LEFT], or [RIGHT].
f When [CUSTOM MASKING] is selected and set to anything other than [OFF] ([PC-1], [PC-2], [PC-3]),
the blanking width can be adjusted to arbitrary shape using a computer and the masking function of the
“Geometric & Setup Management Software”. Up to three adjustment data can be saved.
4) Press qw to adjust the blanking width.
To Next Page
Loading...
