Panasonic PT-REQ12 Series

Chapter 5 Operations — Using the data cloning function
248 - ENGLISH
[ON]
Does not permit the operations of [DATA CLONING] from another projector via LAN.
f Data copy will not be possible when [ON] is set. When it is not necessary to copy data, set [ON] so
that the data is not changed by mistake.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
Copying the data to another projector using USB
Copying projector data to USB memory
1) Insert the USB memory into the <USB> terminal.
2) Press as to select [DATA CLONING].
3) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
4) Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
5) Press as to select [USB MEMORY].
6) Press the <ENTER> button.
f The [SELECT COPY TYPE] screen is displayed.
7) Press as to select [PROJECTOR -> USB MEMORY].
8) Press the <ENTER> button.
f The conrmation screen is displayed.
9) Press qw to select [OK], and press the <ENTER> button.
f Copying of data to the USB memory is started.
Once the copying of data is completed, [Data copy nished.] is displayed.
10) Once the copying of the data is completed, disconnect the USB memory from the <USB> terminal.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f For the USB memory that can be used with the projector and handling of the memory, refer to “Using the USB memory” (x page 83).
f An error message is displayed when saving or reading data to/from the USB memory has failed.
Copying data in the USB memory to the projector
1) Insert the USB memory into the <USB> terminal.
2) Press as to select [DATA CLONING].
3) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
4) Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
5) Press as to select [USB MEMORY].
6) Press the <ENTER> button.
f The [SELECT COPY TYPE] screen is displayed.
7) Press as to select [USB MEMORY -> PROJECTOR].
8) Press the <ENTER> button.
f The conrmation screen is displayed.