Chapter 5 Operations — Using the data cloning function
ENGLISH - 249
9) Press qw to select [OK], and press the <ENTER> button.
f The projector automatically enters standby state and starts copying data from the USB memory to the
projector.
10) Once the copying of the data is completed, disconnect the USB memory from the <USB> terminal.
11) Turn on the power of the projector.
f The copied content is reected to the projector.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f The light source indicators <LIGHT1> / <LIGHT2> and the temperature indicator <TEMP> of the copy destination projector blink while
copying the data. Conrm that the blinking of the indicators stops, and then turn on the projector.
To Next Page
Loading...
