Panasonic PT-REQ12 Series

Chapter 7 Appendix — Technical information
ENGLISH - 269
Using Art-Net function
Since the network function of the projector supports the Art-Net function, you can control the projector settings
with the DMX controller and application software using the Art-Net protocol.
Note
f To use the Art-Net function with the projector, it is necessary to set the password of the administrator account. (x page 202)
f The Art-Net function cannot be used using the “IPv6” protocol. Set the [NETWORK] menu → [WIRED LAN] → [IP VERSION] to either [IPv4]
or [IPv4 & IPv6] and assign the IP address for “IPv4”.
Channel denition
The following table lists the channel denitions used for controlling the projector with the Art-Net function.
Channel settings can be switched using the [NETWORK] menu → [Art-Net] → [Art-Net CHANNEL SETTING]
(x page 206).
The control details assigned to each channel are listed in the following table.
f Channel assignment for [USER] is in factory default setting. Assignment can be changed.
Channel
Control details
[1] [2] [USER]
CHANNEL1 SHUTTER LIGHT OUTPUT LIGHT OUTPUT
CHANNEL2 INPUT SELECT INPUT SELECT INPUT SELECT
CHANNEL3 LENS FUNCTION SELECT LENS POSITION LENS POSITION
CHANNEL4 LENS CONTROL LENS H SHIFT LENS H SHIFT
CHANNEL5 POWER LENS V SHIFT LENS V SHIFT
CHANNEL6 LIGHT OUTPUT LENS FOCUS LENS FOCUS
CHANNEL7 ENABLE/DISABLE LENS ZOOM LENS ZOOM
CHANNEL8 FADE-IN POWER POWER
CHANNEL9 FADE-OUT GEOMETRY GEOMETRY
CHANNEL10 CUSTOM MASKING CUSTOM MASKING CUSTOM MASKING
CHANNEL11 GEOMETRY ENABLE/DISABLE ENABLE/DISABLE
CHANNEL12 NONE NONE NONE
Content that can be controlled by each Art-Net channel setting
l: Can be controlled
Control details
Art-Net channel setting
[1] [2] [USER]
LIGHT OUTPUT
l l l
INPUT SELECT
l l l
LENS FUNCTION SELECT
l
― ―
LENS CONTROL
l
― ―
LENS POSITION ―
l l
LENS H SHIFT ―
l l
LENS V SHIFT ―
l l
LENS FOCUS ―
l l
PERIPHERY FOCUS ― ―
l
LENS ZOOM ―
l l
POWER
l l l
SHUTTER
l
―
l
FADE-IN
l
―
l
FADE-OUT
l
―
l
GEOMETRY
l l l
CUSTOM MASKING
l l l
FREEZE ― ―
l
COLOR ― ―
l
TINT ― ―
l
RASTER PATTERN ― ―
l
ENABLE/DISABLE
l l l