Chapter 5 Operations — Using HDMI CEC function
ENGLISH - 251
Menu operation of CEC-compatible device
When the setting menu of the CEC-compatible device is displayed, you can use the ▲▼◀▶buttons and
<ENTER> button of the remote control to operate the menu.
About the power link operations
By setting the [PROJECTOR SETUP] menu → [HDMI CEC] → [PROJECTOR -> DEVICE] / [DEVICE ->
PROJECTOR] to a setting other than [DISABLE], the following operations can be achieved.
The link setting of [PROJECTOR -> DEVICE]
r When the setting is [POWER OFF] or [POWER ON / OFF]
f When you turn o the power of the projector and put it in standby mode, all CEC-compatible devices connected
to the <HDMI IN 1> terminal, <HDMI IN 2> terminal and Function Board will enter standby mode.
r When the setting is [POWER ON / OFF]
f If you turn on the projector and start projection, the CEC-compatible device connected to the <HDMI IN 1>
terminal, <HDMI IN 2> terminal or Function Board will turn on.
The link setting of [DEVICE -> PROJECTOR]
r When the setting is [POWER ON] or [POWER ON / OFF]
f While the projector is in standby, if the CEC-compatible device connected to the <HDMI IN 1> terminal, <HDMI
IN 2> terminal or Function Board is turned on, the projector turns on, starts projection, and switches to the input
that the CEC-compatible device is connected.
f While the projector is in standby, if the CEC-compatible device starts playing, the projector turns on, starts
projection, and switches to the input that the CEC-compatible device is connected.
f While the projector is turned on, if the CEC-compatible device starts playing, the projector switches to the input
that the CEC-compatible device is connected.
r When the setting is [POWER ON / OFF]
f While the projector is turned on, if the CEC-compatible device connected to the <HDMI IN 1> terminal, <HDMI
IN 2> terminal or Function Board is turned o, the projector turns o and enters standby mode.
Note
f When [DEVICE -> PROJECTOR] menu is set to [POWER ON / OFF], the link operations are only available when the
CEC-compatible devices supports.
f Depending on the status of the device, it may not operate normally such as when the projector or the CEC-compatible device is starting up.
f The connected CEC-compatible device may not support the link operation described in the manual. Not all the operations of the CEC-
compatible device are warranted.
To Next Page
Loading...
