Panasonic PT-REQ12 Series

Chapter 4 Settings — [PROJECTOR SETUP] menu
160 - ENGLISH
5 Display the status by color.
Green: There is an allowance for brightness correction.
Yellow: There is little allowance for brightness correction.
Red: There is a brightness control error.
6 Display error detailed messages.
7 Display error messages.
When the message [Failed to apply BRIGHTNESS CONTROL to some projectors.] appears, it means that synchronization with the
projector displayed in red has failed.
Press as to select the projector displayed in red, and press the <ENTER> button to display the error details.
8 Update to the latest status information.
r Error details
Error message Measures to take
[Exceed maximum number of
projectors.]
f Limit the number of projectors in one group to eight.
f To synchronize nine or more projectors, use a computer and “Multi Monitoring & Control
Software”
*1
.
[Please check the COMMAND
CONTROL setting.]
f Set the password of the administrator account.
f Set [NETWORK CONTROL] → [COMMAND CONTROL] to [ON] for the projector in error.
f Set [NETWORK CONTROL] → [COMMAND PORT] of all linked projectors to the same value.
[Please check the USER NAME
and PASSWORD in the COMMAND
CONTROL setting.]
f Set the administrator account (user name and password) of all linked projectors to the same
setting.
[Cannot apply BRIGHTNESS
CONTROL. Please check projector
status.]
f The projector is in standby. Switch on the power.
[Brightness Sensor Error]
f There is a problem with the brightness sensor. If problems persist even after switching on the
power, consult your dealer.
*1 “Multi Monitoring & Control Software” can be downloaded from the following website.
https://panasonic.net/cns/projector/
Note
f If the synchronized projectors are not displayed in the list, check the following:
g Are there devices with the same IP address on the network?
g Are the LAN cables connected correctly? (x page 209)
g Are the subnets of the projectors the same?
g Are the same [LINK] settings applied to a group?
f Refer to [PROJECTOR NAME] (x page 199) or “[Network cong] page” (x page 227) on how to change the projector name.
Setting [STARTUP CALIBRATION]
Set whether to measure the brightness and color of the light source when the power is turned on.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [STARTUP CALIBRATION].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Does not measure the brightness and color of the light source when the power is turned on.
[ON]
Measures the brightness and color of the light source by the brightness sensor after the power is
turned on and the light source is illuminated.
Note
f The [STARTUP CALIBRATION] setting will be reected at the time when the item is switched using qw.
f The [STARTUP CALIBRATION] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [STARTUP CALIBRATION]
Setting [REGULAR CALIBRATION]
Set whether to measure the brightness and color of the light source at a specied time.
1) Press as to select [BRIGHTNESS CONTROL].