Panasonic PT-REQ12 Series

Chapter 5 Operations — Using the web control function
238 - ENGLISH
r [Server]
Congure the setting required to access the projector assigned to a server using the control system.
1
2
3
4
5
6
7
10
8
9
1 [Use TLS]
Sets the secure communication.
[Disable]:
Performs the unsecured communication.
[Enable]:
Performs the secure communication using TLS (Transport
Layer Security).
2 [IP ID]
Sets the IP ID used to determine the projector on the network.
(A number up to four digits)
3 [Non Secure Port]
Sets the port number to be used with the unsecured
communication.
Default value: 41794
4 [Secure Port]
Sets the port number to be used with the secure
communication.
Default value: 41796
5 [Authentication]
Select the authentication with the connection destination used
with the secure communication.
[Disable]:
Does not perform the connection authentication.
[Enable]:
Performs the connection authentication.
6 [User Name]
Enter the user name used for the connection authentication.
(Up to 20 half-width characters)
7 [Password]
Enter the password used for the connection authentication. (Up
to 20 half-width characters)
8 [Crestron Fusion in the Cloud (FITC)]
Sets whether to use the Fusion server in the Cloud.
[Disable]:
Does not use the Fusion server in the Cloud.
[Enable]:
Uses the Fusion server in the Cloud.
9 [FITC URL]
Enter the URL of the Fusion server in the Cloud.
10 [Submit]
Updates the [Server] setting.
Note
f [Use TLS] will be xed to [Disable] if neither the server certicate nor the self-signed certicate is installed.
f When [Use TLS] is set to [Disable], [Authentication] is xed to [Disable], and [Secure Port] cannot be set.
f When [Crestron Fusion in the Cloud (FITC)] is set to [Disable], [FITC URL] cannot be entered.
r [Auto Discovery]
Set the standby process against the search protocol of the control system and the application software.
1
2
1 [Auto Discovery]
[Disable]:
Disables the standby process.
[Enable]:
Enables the standby process and enables the automatic
detection of the projector.
2 [Submit]
Update the [Auto Discovery] setting.