Panasonic PT-REQ12 Series

Chapter 5 Operations — Updating the rmware
256 - ENGLISH
9) Click [Next].
f The update conrmation screen is displayed.
10) Click [Start].
f Update is started.
f The light source indicator <LIGHT1> and the light source indicator <LIGHT2> on the projector blink red
alternately while updating.
f Elapsed time and rough progress can be conrmed in the update status display screen. The required time
is approximately 20 minutes.
11) Confirm the completion of the update.
f Once the update is completed, the completion conrmation screen is displayed.
f To continue to update the rmware of another projector, click [Yes]. The connection setting screen in Step
7) is displayed.
f To end the update tool, click [No].
12) Confirm the firmware version.
f Turn on the power of the projector and conrm the rmware version in the [STATUS] screen.
Attention
f Do not turn o󰀨 the main power of the projector or disconnect the LAN cable while updating.