1-2 Getting Started
650V AC Drive
About this Manual
This manual is intended for use by the installer, user and programmer of the 650V drive. It
assumes a reasonable level of understanding in these three disciplines.
Note:
Please read all Safety Information before proceeding with the installation and operation
of this unit.
Enter the “Model Number” from the rating label into the table at the front of this manual. It is
important that you pass these manuals on to any new user of this unit.
Initial Steps
Use the manuals to help you plan the following:
Installation
Know your requirements:
• certification requirements, CE/UL/CUL conformance
• wall-mount or enclosure?
• conformance with local installation requirements
• supply and cabling requirements
Operation
Know your operator:
• how is it to be operated, local and/or remote?
• what level of user is going to operate the unit?
Programming (Keypad or suitable PC programming tool only)
Know your application:
• install the most appropriate Application
• plan your “block diagram programming”
• enter a password to guard against illicit or accidental changes
• customise the Keypad to the application
How the Manual is Organised
The manual is divided into chapters and paragraphs. Page numbering restarts with every
chapter, i.e. 5-3 is Chapter 5, page 3.
Application Block Diagrams
You will find these at the rear of the manual. They will become your programming tool as you
become more familiar with the 650V unit’s software.
Software Product Manual
An accompanying Software Product Manual is available for download from the Parker SSD
Drives website: www.parker.com/ssd
To Next Page
Loading...
