Parker 650V series - How to Change a Parameter Value; Resetting to Factory Defaults (2-Button Reset); Selecting Local or Remote Control; Special Menu Features

The Keypad 5-5
650V AC Drive
Password Protection
When activated, an odd-numbered password prevents unauthorised parameter modification by
making all parameters read-only. The local setpoint is not made read-only if an even-numbered
password is used. Password protection is set-up using the
parameter
Steps
ACTIVATE
TEMPORARY DE-ACTIVATION
REMOVE PASSWORD
Actions
Display
Actions
Display
Actions
Display
1
Go to
Press
Try to edit any
parameter with
password activated
→
Go to
Press
→
2
Enter new
password using
for example
Enter current
password using
for example
Enter current
password using
for example
3
Press
repeatedly until
top of menu is
reached
, Remote
Setpoint or
Local Setpoint
Press
Original
parameter
displayed,
password
de-activated
Press
Reset to 0000
using
4
Press to
activate
password
, Remote
Setpoint or
Local Setpoint
A drive will power-
up with the last
password status. Temporary de-
activation is lost on power-down.
Press to
remove
password
Default = 0000, de-activated
Any other value is a password
Quick Application Selection
You can navigate immediately to the
APPLICATION parameter,
P
1, from power-up, as
shown opposite.
Then, press the
key to display the current
Application.
Use the
keys to select the appropriate Application by number.
Press the
key to load the Application.
Refer to Chapter 13: "Applications" for further information.
Hold down the key opposite:
Power-up the drive, continue
to hold for at least 1 second
HOLD