Parker 650V series - CE Marking for EMC - Who Is Responsible; CE Marking for Low Voltage Directive; European Directives and the CE Mark

10-12 Certification for the Drive
650V AC Drive
Certificates
652V
EC DECLARATIONS OF CONFORMITY
Date CE marked first applied: 01.04.2000
Issued for
EMC Directive Low Voltage Directive
The drive is CE
compliance
with the EMC
Directive when
the unit is used
as relevant
apparatus.
In accordance with the EEC Directive
2004/108/EC
We Parker SSD Drives, address as below,
declare under our sole responsibility that the
above Electronic Products when installed and
operated with reference to the instructions in
the Product Manual (provided with each piece
of equipment) is in accordance with the relevant
clauses from the following standard:-
* BSEN61800-3 (2004)
In accordance with the EEC Directive
2006/95/EC
We Parker SSD Drives, address as below,
declare under our sole responsibility that the
above Electronic Products when installed and
operated with reference to the instructions in
the Product Manual
(provided with each piece of equipment), is in
accordance with the relevant clauses from the
following standard :-
EN50178 (1998)
marked in
accordance with
the low voltage
directive for
electrical
equipment and
appliances in the
voltage range
when installed
correctly.
MANUFACTURERS DECLARATIONS
This is
EMC Declaration Machinery Directive
Since the
provided to
aid your
justification
for EMC
compliance
when the unit
is used as a
component.
We Parker SSD Drives, address as below,
declare under our sole responsibility that the
above Electronic Products when installed and
operated with reference to the instructions in
the Product Manual (provided with each piece
of equipment) is in accordance with the
relevant clauses from the following standard:-
* BSEN61800-3 (2004)
The above Electronic Products
are components to be incorporated into
machinery and may not be operated alone.
The complete machinery or installation using
this equipment may only be put into service
when the safety considerations of the Directive
2006/42/EC are fully adhered to.
Particular reference should be made to
EN60204-1 (Safety of Machinery - Electrical
Equipment of Machines).
All instructions, warnings and safety
information of the Product Manual must be
adhered to.
potential hazards
are mainly
electrical rather
than mechanical,
the drive does not
fall under the
machinery
directive.
However, we do
supply a
manufacturer's
declaration for
when the drive is
used (as a
component) in
machinery.
Dr Martin Payn (Conformance Officer)
* Compliant with the immunity requirements of the Standard without specified EMC filters.
Parker Hannifin Ltd., Automation Group, SSD Drives Europe
NEW COURTWICK LANE, LITTLEHAMPTON, WEST SUSSEX BN17 7RZ
TELEPHONE: +44(0)1903 737000 FAX: +44(0)1903 737100
Registered Number: 4806503 England. Registered Office: 55 Maylands Avenue, Hemel Hempstead, Herts HP2 4SJ