Pendulum CNT-90 Series Programmer's Handbook

8-18 Command Reference
:CALCulate :LIMit :FCOunt?
Number of Limit Failure Counts
The command returns the total number of times the set lower and upper limits
have been passed since the counter was last reset by :CALC:LIM:CLEAR or auto
-
matically by :INIT if :CALC:LIM:CLEAR:AUTO ON has been activated.
In other words, the returned value is the sum of the values returned by :CALCu
-
late:LIMit:FCOunt:LOWer? and :CALCulate:LIMit:FCOunt:UPPer?
Returned format: < No. of counts>¿
:CALCulate :LIMit :FCOunt :UPPer?
Number of Limit Failure Counts
The command returns the number of times the set upper limit has been passed
since the counter was last reset by :CALC:LIM:CLEAR or automatically by :INIT
if :CALC:LIM:CLEAR:AUTO ON has been activated.
Returned format: < No. of counts>¿

Pendulum CNT-90 Series Specifications

General

Brand	Pendulum
Model	CNT-90 Series
Category	Measuring Instruments
Language	English