EasyManuals Logo

Pendulum CNT-90 Series Programmer's Handbook

Pendulum CNT-90 Series
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
Sense Command
Subsystems
Depending on application, you can select
different input channels and input charac
-
teristics.
n
Switchbox
In automatic test systems, it is difficult to
swap BNC cables when you need to mea-
sure on several measuring points. With
the '9X' you can select from two different
basic inputs (A and B), on which the
counter can measure directly without the
need for external switching devices.
n
Prescaling
For all measuring functions except time
interval, rise/fall time, phase and time
stamping, the maximum input A or B fre-
quency is 300 MHz.
For the measuring functions explicitly
mentioned above, the counter has a max
repetition rate of 160 MHz.
For the measuring functions Frequency
and Period Average, the signal to Input A
or Input B is prescaled by a factor of 2.
For Frequency in Burst, PRF and Num
-
ber of Cycles in Burst, the signal is
prescaled by a factor of 2 if the command
:SENSe:FREQuency:BURSt:PREScaler is
set to ON. This is also the default condi
-
tion.
Using the Subsystems
Sense Command Subsystems 6-9

Table of Contents

Other manuals for Pendulum CNT-90 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pendulum CNT-90 Series and is the answer not in the manual?

Pendulum CNT-90 Series Specifications

General IconGeneral
BrandPendulum
ModelCNT-90 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals