EasyManuals Logo

Pendulum CNT-90 Series Programmer's Handbook

Pendulum CNT-90 Series
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #161 background imageLoading...
Page #161 background image
Command Reference 8-53
+
The array size for :MEASure and :CONFigure, and the channels, are expression
data that must be within parentheses ( ).
The question mark at the end of the commands is only valid for :MEASure,
where a result is expected. It must be deleted for :CONFigure, which is a set
-
ting command only.
The default channels, which the counter use when you omit the channels in the
command, are printed in italics in the channel list on the following pages.
+
If you want to check what function and channels the counter is currently using,
send :CONF?
This query gives the same answer as :FUNC? in the SENSe subsystem
Measurement Function
Set up the Instrument, Perform Measurement, and Read Data
:MEASure
[:SCALar]<Measuring Function>?
[<Parameters>][,(<Channels>)]
:ARRay<Measuring Function>?
8
(<Array Size>)[,<Parameters>][,(<Channels>)]
:MEMory?
8
[<N>]
:MEMory<N>?

Table of Contents

Other manuals for Pendulum CNT-90 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pendulum CNT-90 Series and is the answer not in the manual?

Pendulum CNT-90 Series Specifications

General IconGeneral
Resolution1 mHz (0.001 Hz)
Input Channels2
Frequency Range0.001 Hz to 2.4 GHz
InterfacesUSB
FunctionsFrequency, Period, Time Interval, Totalize, Ratio, Phase, Duty Cycle
Measurement Range0.001 Hz to 2.4 GHz
Accuracy±1 ppm
Operating Temperature Range0°C to 50°C
Power Supply100-240 VAC, 50-60 Hz
InterfaceUSB

Related product manuals